PFR REVIEW QUESTIONS

PFR
What is the difference between load balancing and load sharing?
What is the job of the mc in pfr?
What is the job if border routers?
what are the requirements for pft as regards internal and external interface?
Is this requirement per device?
what happens if pfr is not specfied on interface?
what is the requirement for routing in pfr?
how would you define a border router connecting to master of 2.2.2.2?
How could you define a md5 authentication for this?
what do we need to define on mc for border router r1 1.1.1.1 and border router 3.3.3.3
how can you check on the master if the connections have been successifully established?
what would you use to define max difference of 20 percent in utilization?
What is different between passive and active mode + which existing ios features do the use?
What is the default monitoring in pfr??
How could we say to only monitor utilization?
what is the default mode control for pfr?
How can we change this to be active in routing?
What is the backoff value in pfr?
how would set pfr to automatic learning based on throughput
how would set so it continiously monitors does not stop and take breaks
What is the default high utilization?
What tag does pfr assign the static routes?
what can we use this tag for ??
how could we tell under the auto learn so that evaluates bgp table rather then the cef fib?
What is the parent route issue in pfr??
What types of routes can parent routes be?
how could we tell pfr to only auto learn www?
How could we in auto learn tell pfr to only looking icmp traffic destined to 5.5.5.5?
how do you turn on logging for pfr?
how can we disable auto learn
how could we tell pfr to aggregate /24
what is a learn list + how do we define it
How can we use pbr mode?
how do we match traffic in pbr mode?
what is important about the acl in pbr mode?
what must we set?
how do you view the pbr route map on the border routers?
what are the requirement when we have multiple border routers?
what do we need to define on the oer master for this interface?
how could we change pfr only to account for delay not throught put?
what is the difference betweeen the relative delay threshold vs the abosultes?
what is the mode fast?
what is a link group + how do we define links groups?
what is flexible netflow?
what 4 steps to we need to take to apply a flexible netflow?
What are the difference between a match and collect statment?
how can we define flexible netflow to integrate with pfr